How to Set Up Jeep Garage Door Opener?

Jeep garage door opener is one of beneficial conveniences that you can get from the Jeep newer version. This built-in garage opener is named as the home link system. This Homelink system refers to a system that is able to connect between your jeep and your garage door. That is why you can open your garage door automatically without wasting your time and energy. For further information related to this garage door opener for jeep, you are able to found it in the following descriptions.

jeep garage door opener_02

Setting up the homelink system

Before setting up the homelink system, you need to know several essential things. One of the essential things refers to where you park your jeep. It is very recommended for you to park your jeep outside your home garage. It is important to do when you try to set up the home link system. Another thing that you need to know is the battery. As there is a kind of some remote controls which are available to choose for this homelink transmitter named hand-held transmitter need a new battery to operate and provide you with greater perfomances.

Four easy ways to set up the homelink system

In order to activate, set up and program your garage door opener, you have to do some steps. There are 4 easy steps or ways that are able to follow in programming the homelink system. First of all, you need to press and hold the two outer transmitter buttons for a while. After your EVIC display shows “channel cleared”, you have to release the buttons. It takes time around 20 seconds. However, you should never press and hold the buttons for more than 30 seconds. In addition, you should do the same action for 2nd or 3rd hand-held transmitter.

READ MORE  How To Find Sliding Glass Door Replacement Hardware

Second, place your hand-held transmitter around 3 up to 8 cm away from the homelink buttons. Then press and hold the two buttons simultaneously. Do it until the EVIC display shows “channel 1/2/3 training” and “channel 1/2/3 trained”. If it shows ”did not train”, repeat the 2nd step. Don’t repeat the first step.

jeep liberty garage door opener

Third, press and hold again until the EVIC display shows “channel 1/2/3 transmit”. If that notification is shown, it means that your setting up is complete. The press “learn” or smart at the garage door receiver. The garage door receiver is the one with a hanging antenna. You have to press the button around 30 seconds. At this period, you are able to activate your device.

Fourth, back to your vehicle. Now, you need to press and hold around 2 seconds of your set-up buttons. Then, do press, hold and release again for the 2nd time. You may need to repeat hold, press and release depend on the manufacture of your homelink system. By doing this step, you are able to activate your garage door opener. Finally, you have finished setting up your homelink system or Jeep garage door opener. If you want to look for detail information, you are able to visit the home link system’s website.

door garage jeep jeep garage door opener opener

Leave a Comment

Leave a Reply

Copyright © House Design 2018